
Mechanical Installation & Cabling | MultiVOIP User Guide |
|
|
d. Identify the channels on which the DID interface will be used.
Ch 5
U7
Upper Circuit Card
MVP810 only
Ch 6 | Ch 7 | Ch 8 |
U9 | U8 | U10 |
Jumpers
}
|
|
| Main Circuit Card |
|
|
| |
Ch 1 | Ch 2 | Ch 3 | Ch 4 |
|
|
| } |
|
|
| Jumpers |
Jumper Configurations
(enlarged)
For DID
Interface type
For
Interface type
Generality:
For channels using the DID interface, the jumper must not straddle across the
For channels using any
Figure 3-7. MVP-410SS/810SS Channel Jumper Settings
e. Position the jumper for each DID channel so that it does not connect the two jumper posts. For DID operation of a voip channel, the MultiVOIP will work properly if you simply remove the jumper altogether, but that is inadviseable because the jumper might be needed later if a different telephony interface is used for that voip channel.
f. Slide the main circuit card back into the MultiVOIP chassis and replace the three screws.
70