Muratec Series 41500E Sending a fax using the FBS, Ltr NextDoc Mem100%, Enter the fax number

Getting started

Sending a fax using the FBS

1	If the machine is already in Fax mode, skip to step 2.
	If the machine is in Copy mode, press COPY/FAX to change to Fax mode.
2	If there isn’t a document in the feeder, skip to step 3.
	If there’s a document in the feeder, remove it.
3	Open the book-cover.
4	Place the document face down on the FBS and align it with the document
	scale on the right, then gently close the book-cover.
	Make sure the document is set beyond the right front corner.
	Important: Gently close the book-cover so that you don’t catch your hands,
	possibly injuring them.
	When a thick document, such as a book, is on the FBS, do not
	press strongly from the top of the book-cover. This may break
5	the contact glass and cause an injury.
	Press BOOK DOC SIZE to select the document size, letter (displayed as Ltr),
	legal (Legl), half-letter (HLtr) or B4. (Half-letter is 8.5″ wide × 5.5″ tall; B4,

widely used internationally, is 10.1″ × 14.3″.)

6 Adjust resolution and contrast if necessary. Press RESOLUTION to change the resolution.

Press CONTRAST, then press or to change the contrast.

7 Enter the fax number.

Also, enter any access codes necessary, just as you would for a regular phone call. (Example: Enter 9 to “dial out” from an office telephone system, or 1 for long-distance.)

Press Start 919725552009_

8 Press START.

By pressing START, you’ve just given your machine a command. In turn, your machine gives this action a command number as it scans the fax document.

This command number appears on the first line of the LCD for a few seconds:

== Command:01 ==

You’ll need this command number to cancel the transmission or to print a stored document (see pages 1.23).

Then your machine will scan the document into the memory.

While your machine scans the document, the LCD will show:

919725552009

Ltr NextDoc Mem100%

9 When the scanning is done, the LCD will show:

Start Scan → Next

Tx Start → Start

If you want to send more pages, proceed to step 10.

Otherwise, press START to start the transmission, and skip to step 11.

10 Place the next page, then press NEXT to start scanning. Note: If necessary, select the document size (see step 5).

To send any more pages, repeat steps 9-10.

Otherwise, press START to start the transmission, and skip to step 11.

1.20