Muratec Series 41500E, MFX-1500E operating instructions Using the Multi paper tray

Press PAPER SIZE? repeatedly until the following display appears:

Press ENTER.

Set the reduction or enlargement rate, if you want. (See “Setting of enlarge- ment or reduction for copying,” page 1.31.)

If you want to make only one copy of each page of the document, skip to step 10. Otherwise, proceed to step 8.

Getting started

5 Adjust resolution and contrast if necessary. Press RESOLUTION to change the resolution.

Press CONTRAST, then press or to change the contrast.

6

7

8 Use the numeric keypad to enter the desired number of copies for each page in the document. You may choose one to 99 copies. Here, we’ve entered “3” to choose a setting of three copies.

9	Press SORT COPY once or twice to “Toggle” (switch on or off) the sorting of
	copies, as desired.
10	Press START to begin the copying process.

Note: To stop the copying before it is through, press STOP.

Note: Thanks to your machine’s QuadAccess® feature (see page 2.37 for more), copying doesn’t keep you incommunicado while in progress: you can start a fax or voice call and even receive a voice call during copying.

Using the Multi paper tray

When you need to use a size of paper not currently loaded in your machine’s paper cassette(s), or when you want to use a special type of paper (such as transparency film), use the Multi paper tray.

Important: If loading transparency (OHP) film into the multi paper tray, be sure that the sheet is designed for laser printers and not for copiers. Also, be sure that the film does not have a paper backing and/or a leading strip. If it does, remove the paper backing and/or strip before insert- ing. Only film should go in, not film with any backing or strip.

1 Either insert the document in the ADF or place it on the FBS.

2 Place a sheet of printout paper on the Multi paper tray. Then align the paper guides to the sheet’s edges and insert the sheet until it comes to a stop.

Note: Place the original document in the same orientation as the paper in the paper source (which you’ll select in step 5, below).

•If you are going to make more than one copy, you should insert the print- out paper only one page at a time.

•You may use letter-, legal- or half-letter sized paper. (Half-letter is 8.5″ wide × 5.5″ tall.)

3

4

5 Then, if necessary, press PAPER SIZE? again to select a same size of recording paper you placed document on the ADF or FBS. You can select either letter-, legal- or half-letter-sized paper.

	Note: When you use transparency film, please select “OHP” mode.
	You can use letter-sized transparency film.
6	If necessary, select desired resolution, contrast, reduction/enlargement rate.
	(See “Setting of enlargement or reduction for copying,” next page.)
7	Press START to begin the copying process.

1.30