Muratec Series 41500E, MFX-1500E Continuous polling, Polling Start Time, Polling End Time 0700

Beyond the Basics

Continuous polling

To set up your machine for continuous polling:

1 Press COM-OPTIONSsix times and then press ENTER. The LCD shows the current time:

Cont Polling

Start Time : 18:30

2 Use the numeric keypad to enter the time your machine should begin the con- tinuous polling. (Use the 24-hour format.) Here, we’ve set it for 7:00 AM.

Cont Polling

Start Time : 07:00

	Note: Press		to move the cursor left, or /PROGRAM to move it right.
3	When the start time is set, press ENTER to save it.The LCD shows:
		Cont Polling
		End Time	:	07:00
4
	Use the numeric keypad to enter the time when your machine should finish
	the continuous polling. (Use the 24-hour format.)Here, we’ve set it for 3:00 PM.
		Cont Polling
		End Time	:	15:00

Note: If you set the end time earlier than the start time, the polling operation will continue until the selected end time tomorrow.

Note: Press to move the cursor left, or /PROGRAM to move it right.

5 When the end time is set, press ENTER to save it.The LCD shows:

Enter Fax Number

_

6 Enter the remote fax machine’s number by either pressing a one-touch key, entering a speed-dial number or using the numeric keypad.

If you are entering only one number for continuous polling, skip to step 8. To add additional fax numbers for this operation, go on to step 7.

7	To add additional fax numbers, press BROADCAST between each one to insert a
	comma then enter the number as in step 6. You can specify up to 30 numbers
	(and/or call groups) for continuous polling.
		Press Start
		[03],9-5551204,S118,
	Important: Do not insert a comma after the last fax number.
	Note: If you enter characters by mistake, press CANCEL to clear them.
8	Press START.

When your machine polls for documents, it dials each number and, upon making contact with the other machine, begins receiving the document as if the other machine had placed the call. It will continue the process throughout the time period you selected in steps 2–5.

Note: When you want to end a continuous polling operation, you must delete it using the Review Commands feature (see page 2.18).

Being polled

Not only can you poll, but you can also be polled. To set up a document for regular polling:

1	If your fax machine is set for Tel Ready reception, press AUTO ANSWER to
	change it to the Auto Answer mode. The Auto Answer light will glow.
	Important: Your machine can’t be polled if it’s in Tel Ready mode.
2	Insert the document.
3	Adjust resolution and contrast if necessary. (Your fax machine will be trans-
	mitting to the machine doing the polling.)
4	Press /PROGRAM, D, 1, ENTER.
	Your fax will scan the document into memory and return to standby mode.

Note: If you want to return to the “Tel Ready” mode after the remote machine has polled your document, press AUTO ANSWER. The Auto Answer light on the control panel will turn off. But do this only after you’re sure the remote machine has polled your document.

Once the remote fax machine polls the document you stored, your fax machine auto- matically erases the document from memory.

2.32