Muratec Series 41500E, MFX-1500E Plug in and power up, Turn off the transport mode

Getting started

Plug in and power up

Important: Be sure you do not turn the power on until after you remove the transport screws. (See “Removing the transport screws,” page 1.7.)

1	Plug one end of the telephone line
	cord into the LINE jack on the
	machine’s rear side. Plug the other
	end of the cord into a standard tele-
	phone wall jack, just as you would
	plug in a phone.
	Note: If you have purchased an
	optional handset, do not con-
	fuse its curled handset cord
	with the uncurled telephone
	line cord.
2	Plug the non-pronged end of the AC
	power cord into the AC power cord jack on the left side of the machine.
3	Plug the pronged end of the AC power cord into a 120 V electrical outlet
	(preferably on a surge suppressor, as mentioned on page 1.7).
	Important: Be sure that you do not turn the power on (next step) until after
	you have removed the transport screws (see page 1.7).
4	Use the AC power switch to turn on your machine. The markings are interna-
	tional standards: I means on, O means off.

It will take a few seconds for the machine to warm up. The display will show:

** Please Wait **

When the machine is ready to use (standby mode), you will see either . . .

Fax Ready		or
Jan 1 2000	0:00
Fax mode			Copy mode

If the machine beeps, its ALARM light glows and the display shows an error message, this means there is a problem of some sort. Please consult “Just in case...,” begin- ning on page 3.1.

Turn off the transport mode

Important: Be sure you do not turn the power on until after you remove the transport screws. (See “Removing the transport screws,” page 1.7.)

To turn off the transport mode:

1 Power up the machine.

If the machine is already in Fax mode, skip to step 3. If the machine is in Copy mode, proceed to step 2.

2 Press COPY/FAX to switch the machine to Fax mode.

3 Press PROGRAM, *, E.

Mirror Locked :On

Program/Enter

4 Select Off by pressing PROGRAM. Then press ENTER to turn off the transport mode. The mirror carriage will move to the home position.

Mirror Locked :Off

Program/Enter

Important: If you must reship the machine to any other location, turn on this mode to move the mirror carriage to the transport position (in step 4, above, press program to set the transport mode to On), then power off and mount the mirror carriage using the four transport screws.

1.12