Muratec MFX-1500E Adjust the monitor speaker’s volume, Attaching an optional handset, Tel Mode

Adjust the monitor speaker’s volume

You can set the volume of the monitor speaker, assuring that on-hook dialing will be as loud (or as soft) as you require.

1	Press MONITOR/CALL on the control panel. You now should hear a dial tone,
	and the display will show:
		** Tel Mode **
	Important: If you don’t hear a dial tone, make sure your fax machine is
		plugged into a working phone line.
2	If the volume you hear is satisfactory, skip to step 4.
	Otherwise, proceed to step 3.
3	Adjust the volume as you wish:
	To turn the volume up, press .

To turns the volume down, press .

The LCD indicates the volume. Here are the possible settings:

Getting started

Attaching an optional handset

You may purchase an optional handset for your fax machine. Here is how to attach the handset.

Important: Do not connect the handset directly to a telephone wall jack. Instead, connect it only to your fax, as these instructions describe.

1 Remove the two screw caps and screws.

2 Using a Phillips-head screwdriver, attach the handset cradle to the rear

** Tel Mode ** Volume:■■ ■■ ■■

** Tel Mode ** Volume:■■ ■■

** Tel Mode ** Volume:■■

** Tel Mode ** Volume:

=Loudest setting.

=Medium setting.

=Low setting.

=Volume off.

side of your machine, using the screws included with the cradle.

3 Plug one end of the handset cord (it’s curled) into the PHONE1 jack on the left of your machine.

4 Press MONITOR/CALL again to hang up.

4 Plug the other end of the handset cord into the jack on the handset. If con- nected to a phone line, your fax machine is now “off-hook.”

Note: The handset has a small “flash” button which you can press while holding the handset, putting the fax machine back “on-hook” until you can hang up the handset properly in step 5.

1.13