Muratec Series 41500E Redialing manually, Changing redial settings, Set # Of Redials

Getting started

Redialing

If your fax call fails, your machine automatically redials it. In this Auto Redial mode, your fax automatically redials the number every few minutes (see “Changing redial settings,” right column) until one of the following happens:

•It reaches the remote fax machine.

•It has attempted the number of redials programmed and has still not connected (see “Changing redial settings,” right column).

While in the Auto Redial mode, the machine can continue to receive faxes and can make as many as 99 fax transmissions.

Note: If you used either the speaker or a handset to dial the call, you must redial manually (see below).

Note: If the last redial attempt fails, your machine may print (and/or display) error messages. For more information, see pages 3.11.

Redialing manually

You can always redial calls manually. And you must redial manually if you used either the monitor speaker or an optional handset to dial the failed call.

To redial a fax call manually without using the monitor speaker or an optional handset:

1 Make sure the document is in the feeder and that the resolution and contrast are set.

2 Press REDIAL/PAUSE, START.

To redial a fax call manually with the monitor speaker or an optional handset:

1 Make sure the document is in the feeder and that the resolution and contrast are set.

2 Press MONITOR/CALL or lift the optional handset to get a dial tone.

3 Press REDIAL/PAUSE.

4 When you hear fax tones from the remote unit, press START.

Note: If a person answers the phone, use the optional handset to tell that person you’re sending a fax. When you hear fax tones, press START.

To redial a voice call manually using the optional handset:

1 Lift the optional handset to get a dial tone.

2 Press REDIAL/PAUSE. When the other person answers, use the optional handset to speak to that person.

Changing redial settings

It’s up to you how many times the fax redials a number and how long it waits between redials (that length of time between calls is the redial interval). To program the redial settings:

1 Press /PROGRAM, J, 0, 6, ENTER.

Set # Of Redials

#(02-15):02

2 Use the numeric keypad to enter the number of redials you want. Choose from 2 to 15 redials. In this example, we’ve entered 03.

Set # Of Redials

#(02-15):03

Important: Enter a leading zero when entering a quantity less than 10.

3 Press ENTER to save the setting.

4 The LCD now shows:

Set Redial Interval

Inter. (1-5):1

5 Use the numeric keypad to enter the length you want between redial attempts. Choose from 1 to 5 minutes. In this example, we’ve chosen 4.

Set Redial Interval

Inter. (1-5):4

6 Press ENTER to save the setting.

1.22