
Configuring the System Settings
Sample Configurations
Sample Standard Configuration
3.Install the SCSI
4.Connect power cables and SCSI cables to the 2 GB SCSI disk drive and the SCSI
5.Install the memory SIMMs in bank 1 on the system baseboard (installed in groups of two SIMMs).
6.Install the PCI Ethernet Adapter in PCI slot 1 (topmost PCI slot).
7.Install the PCI Token Ring Adapter in PCI slot 2 (below the PCI Ethernet adapter).
8.Install the ISA Video Board in EISA/ISA slot 2 (second EISA/ISA slot from the top).
To configure the system settings in the BIOS Setup Utility, follow these steps:
1.Turn on power to the system. Observe that the memory test is executed (memory addresses should be rapidly displayed in upper
2.Press [Control] + [Alt] + [Esc] when prompted to enter the BIOS Setup Utility.
3.Select Load System Defaults and press [Enter].
4.Select Basic System Configuration. To go from page to page, press [Page Down] or [Page Up].
NCR S10 Desktop Server User Guide |