NCR S10 manual Sample RAID Configuration

Sample Configurations

Sample RAID Configuration

2.Select M5 from the Advanced Configuration menu.

Note: Refer to Chapter 5 for instructions on configuring the memory correctly.

The PCI Adapter IRQ values entered below do not set the IRQ level for PCI Adapters.

PCI Adapter IRQ settings are set in the BIOS Setup Utility. You enter the IRQ settings in the EISA Configuration Utility so that the EISA Configuration Utility does not assign IRQ values to EISA Adapters that have already been used for PCI Adapters.

Make sure the parallel port and serial ports are configured the same way as in the BIOS Setup Utility.

3.Configure the baseboard options as follows:

System Memory Function
Base System Memory	[640 K Base Mem]
4-16 MB Ext Memory	[16 MB Ext Mem...]
16-64 MB Ext Memory	[Ctrl-R to add...]
PCI Devices IRQ assignment
On board 7870 SCSI	[Disabled]
PCI Slot 1	[Disabled]*
PCI Slot 2	[Disabled]*
PCI Slot 3	[Disabled]*
System BIOS Type	[E, F Segment...]
Peripheral Device Status
Mouse Port	[Enabled]
Keyboard Port	[Enabled]
Floppy Disk Controller	[Enabled]
IDE HDD Interface	[Disabled]

NCR S10 Desktop Server User Guide C-21