NCR S10 manual Configuring the System Settings

Sample Configurations

Sample RAID Configuration

Configuring the System Settings

10.Install the PCI RAID Adapter in PCI slot 3.

The procedure is the same as the procedure for configuring the system settings in the Standard Configuration. The procedure is repeated here for your convenience.

To configure the system settings, follow these steps:

1.Turn on power to the system. Observe that the memory test is executed (memory addresses should be rapidly displayed in upper left-hand corner of screen). Ignore any memory size mismatch error displayed on the screen.

2.Press [Control] + [Alt] + [Esc] when prompted to enter the BIOS Setup Utility.

3.Select Load System Setup Defaults and press [Enter].

4.Select Basic System Configuration. To go from page to page, press [Page Down] or [Page Up].

5.Go to Page 2 and set parameters as follows, in the order indicated:

Hard Disk Block Mode	[Disabled]
Advanced PIO Mode	[Disabled]
Hard Disk Size > 504 MB	[Disabled]
Hard Disk 32-Bit Access	[Disabled]
Auto Configuration Mode	[Disabled]
Fast Boot Mode	[Disabled]
Num Lock After Boot	[Enabled]

C-14 NCR S10 Desktop Server User Guide