NCR S10 manual Configuring Memory and Other Baseboard Settings

Sample Configurations

Sample RAID Configuration

Configuring the

Memory and Other

Baseboard Settings

Extended BIOS Translation...	[Enabled]
Display <CTRL-A> Message During	[Enabled]
BIOS Initialization...
Multiple LUN Support	[Disabled]
BIOS Support for More than 2...	[Enabled]

7.Press [Enter] to return to previous menu.

8.Press [Esc] until prompted to save configuration. Save the configuration and the system reboots.

The procedure is the same as the procedure for configuring the memory and other baseboard settings in the Standard Configuration. The procedure is repeated here for your convenience.

Sometimes the EISA Configuration Utility will not boot. If this happens, perform the following procedure:

1.Using the BIOS Setup Utility, disable all PCI adapters.

2.Boot the EISA Configuration Utility.

3.Configure the system.

4.Go back into the BIOS Setup Utility, and re-enable the PCI adapters.

To configure memory and other baseboard settings, follow these steps:

1.Insert the EISA Configuration Utility in the diskette drive. Observe that the EISA Configuration Utility boots properly.

C-20 NCR S10 Desktop Server User Guide