NCR S10 manual Sample RAID Configuration

Sample Configurations

Sample RAID Configuration

connected to the Mylex PCI RAID adapter should be configured as SCSI ID 0, 1, and 2, for use in a RAID configuration.

2.Install the SCSI CD-ROM drive in the bottom front drive bay.

3.Install the system boot drive (SCSI ID 0) in a 5.25- inch to 3.5-inch conversion bracket and install it in the middle, front drive bay.

4.Of the three remaining drives, install one in conversion bracket and install it in the bottom, front drive bay. Install the remaining two drives over the power supply.

5.Connect power cables and a wide SCSI cable to the two drives over the power supply and the drive in the top, front drive bay. Connect this wide SCSI cable to the PCI RAID controller.

6.Connect power cables and a narrow SCSI cable to the drive in the middle, front drive bay and the SCSI CD-ROM drive. Connect this narrow SCSI cable to the onboard AIC-7870 controller.

7.Install the memory SIMMs in banks 1 and 2 on the system baseboard (installed in groups of two SIMMs).

8.Install the PCI Ethernet Adapter in PCI slot 1 (topmost PCI slot).

9.Install the PCI Token Ring Adapter in PCI slot 2.

NCR S10 Desktop Server User Guide C-13