
Installing the System
Installing Drives
7.Run Setup to reconfigure the system and to format the fixed disk, if necessary.
To install a tape drive, follow these steps:
Installing a Tape Drive
1.Unplug all cables connected to the drives.
2.Locate the two holding tabs that attach the drive housing to the system unit and push both tabs outward, one at a time, to release the drive housing. See Figure
3.Carefully lift up the drive housing.
4.Detach the
5.Slide the tape drive into the drive bay and secure it with screws. See Figure
6.Plug one end of the data cable into the connector on the tape controller and the other end to the rear of the tape drive.
7.Plug the power supply cable to the power connector on the rear of the tape drive.
NCR S10 Desktop Server User Guide |