NCT Group 2000M, 99M manual Clamping the Cutting Feed

6 The Feed

The Table below shows the maximum programmable range of values at address F, for various cases.

input units

output units

increment system

value range of address F

unit

		IS-A	0.001 - 250000	mm
		IS-B	0.0001 - 25000	or
				deg/min
		IS-C	0.00001 - 2500
mm	mm	IS-A	0.0001 - 5000	mm
		IS-B	0.00001 - 500	or
				deg/rev
		IS-C	0.000001 - 50
		IS-A	0.0001 - 9842.5197	inch
		IS-B	0.00001 - 984.25197	or
				deg/min
		IS-C	0.000001 - 98.25197
inch	mm	IS-A	0.00001 - 196.85039	inch
		IS-B	0.000001 - 19.685039	or
				deg/rev
		IS-C	0.0000001 - 1.9685039
		IS-A	0.0001 - 25000	inch
		IS-B	0.00001 - 2500	or
				deg/min
		IS-C	0.000001 - 250
inch	inch	IS-A	0.00001 - 500	inch
		IS-B	0.000001 - 50	or
				deg/rev
		IS-C	0.0000001 - 5
		IS-A	0.001 - 250000	mm
		IS-B	0.0001-25000	or
				deg/min
		IS-C	0.00001-2500
mm	inch	IS-A	0.0001 - 5000	mm
		IS-B	0.00001-500	or
				deg/rev
		IS-C	0.000001-50

6.2.2 Clamping the Cutting Feed

The maximum programmable feed on a particular machine can be clamped (set as a parameter) by the manufacturer of the machine. The value set there invariably refers to minutes. That value is also the speed of DRY RUN. If a programmed feed higher than that is set, the control will clamp it

46