NETGEAR FVG318NA manual Enabling Remote Management Access

Models: FVG318NA

1 176
Download 176 pages 33.43 Kb
Page 138
Image 138

ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual

You have an ISDN firewall on your home network for connecting to the company where you are employed. This firewall’s address on your LAN is 192.168.0.100.

Your company’s network is 134.177.0.0.

When you first configured your firewall, two implicit static routes were created. A default route was created with your ISP as the gateway, and a second static route was created to your local network for all 192.168.0.x addresses. With this configuration, if you attempt to access a device on the 134.177.0.0 network, your firewall will forward your request to the ISP. The ISP forwards your request to the company where you are employed, and the request will likely be denied by the company’s firewall.

In this case you must define a static route, telling your firewall that 134.177.0.0 should be accessed through the ISDN firewall at 192.168.0.100. The static route would look like Figure 8-4.

In this example:

The Destination IP Address and IP Subnet Mask fields specify that this static route applies to all 134.177.x.x addresses.

The Gateway IP Address fields specifies that all traffic for these addresses should be forwarded to the ISDN firewall at 192.168.0.100.

A Metric value of 1 will work since the ISDN firewall is on the LAN.

Private is selected only as a precautionary security measure in case RIP is activated.

Enabling Remote Management Access

Using the Remote Management page, you can allow a user or users on the Internet to configure, upgrade and check the status of your FVG318 VPN firewall.

Note: Be sure to change the firewall’s default configuration password to a very secure password. The ideal password should contain no dictionary words from any

language, and should be a mixture of letters (both upper and lower case), numbers, and symbols. Your password can be up to 30 characters.

To configure your firewall for Remote Management:

1.Select Administration > Remote Management from the main menu. The Remote Management screen will display.

8-8

Advanced Configuration

v1.0, September 2007

Page 138
Image 138
NETGEAR FVG318NA manual Enabling Remote Management Access