ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
VPN Configuration of NETGEAR FVG318 C-11
v1.0, September 2007
• Pre-Shared Key: 12345678 (in this example), must be the same at both VPN tunnel
endpoints
• Remote WAN IP address: 22.23.24.25 (in this example), must be unique at each VPN
tunnel endpoint
• Remote LAN IP Subnet
– IP Address: 172.23.9.1 (in this example), must be unique at each VPN tunnel endpoint
– Subnet Mask: 255.255.255.0 (in this example)
3. Log in to the FVL328 labeled Gateway B.
Log in at the default address of http://192.168.0.1 with the default user name of admin and
default password of password (or using whatever password and LAN address you have
chosen).
4. Repeat the process using the VPN Wizard to configure the FVL328 at Gateway B.
• Connection Name: Scenario_1 (in this example)
• Pre-Shared Key: 12345678 (in this example), must be the same at both VPN tunnel
endpoints
• Remote WAN IP address: 14.15.16.17 (in this example), must be unique at each VPN
tunnel endpoint
• Remote LAN IP Subnet
– IP Address: 10.5.6.1 (in this example), must be unique at each VPN tunnel endpoint
– Subnet Mask: 255.255.255.0 (in this example)
All traffic from the range of LAN IP addresses specified on FVG318 A and FVL328 B will now
flow over a secure VPN tunnel once the VPN tunnel is initiated (see “Initiating and Checking the
VPN Connections” on page C-12).
Viewing and Editing the VPN Parameters
The VPN Wizard sets up a VPN tunnel using the default parameters from the VPN Consortium
(VPNC).
• The Pre-Shared Key must be the same at both VPN tunnel endpoints.
Note: Based on the network addresses used in this example, you would log in to the
LAN IP address of http://172.23.9.1 at Gateway B.