ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
Setting Up a Gateway-to-Gateway VPN Configuration
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC 
default parameters listed in Table
not covered by these
|
|
|
|
| FVG318 VPN Firewall |
FVG318 VPN Firewall | ||
|
|
|
Figure
The following procedure will show how to set the LAN IPs on each FVG318 to different subnets and configure each properly for the Internet.
•The LAN IP address ranges of each VPN endpoint must be different. The connection will fail if both are using the NETGEAR default address range of 192.168.0.x.
•In this example, LAN A uses 192.168.0.1 and LAN B uses 192.168.3.1.
To configure a
1.Log in to the FVG318 on LAN A at its default LAN address of http://192.168.0.1 with its default user name of admin and password of password.
2.Select VPN > VPN Wizard from the main menu. The VPN Wizard screen will display.
3.Select the Gateway radio box in the About VPN Wizard section.
4.In the Connection Name and Remote IP Type section, enter the Connection Name and the pre- shared key.
Basic Virtual Private Networking |
