Nortel Networks Option 11C Mini manual Activating a default model with a character display

Page 246 of 332 Chapter 17 — Connecting the telephones

Activating a default model with a character display

Procedure 35

Activating a default model telephone with a character display

1Plug the telephone set into the jack and wait 20 seconds before you lift the handset. If you do not receive a dial tone, replace the handset and wait another 10 seconds before lifting the handset again. Repeat this procedure until you receive dial tone.

If successful, the character display shows either “MODEL? X” (if the telephone relocation feature is not in use) or “RELOC OR MODEL? X” (if the telephone relocation feature is in use). “X” represents the default model for the telephone that you are activating.

Note: If you do not see the prompt “MODEL X” after lifting the handset, disconnect the telephone from the wall jack. Wait five seconds, and insert the telephone into the jack again. The telephone now shows “MODEL X” when you lift the handset.

Note: The system requires the 20 second time interval to determine if the set is new or if it is being relocated using the Modular Telephone Relocation feature.

2Press the pound key (#) to select the default model.

The character display shows “OK, EXTENSION? XXXX”. “XXXX” represents the default extension number for this telephone type.

553-3021-209 Standard 3.00 April 2000