Nortel Networks Option 11C Mini manual Miscellaneous items for installation

Page 40 of 332 Chapter 2 — Identifying the Option 11C Mini equipment

Table 6

Option 11C Mini miscellaneous cables and wires (Continued)

Cable and wire	Purpose / description
#6 AWG (20 mm2) insulated	The #6 AWG (20 mm2) insulated
ground wire (Europe)	ground wire connects a chassis to a
	building ground source.
#8 AWG (10 mm2) insulated	The #8 AWG (10 mm2) connects a
ground wire (Germany)	chassis to a building ground source.
Cross-connect wire	The cross-connect wire makes cross
	connections at the cross-connect
	terminal.

Note 1: This cable is available in different versions, depending on local EMC specifications.

Note 2: These cables are not supported under EMC specifications VL43.140P.

Miscellaneous items for installation

The following is a list of miscellaneous items that you can use as part of Option 11C Mini system installation. Quantities needed depend on the site and customer requirements:

•QUA6 Power Failure Transfer Units (PFTU) to transfer lines during a power or system failure

•NTBK80 grounding block

•modems or Data Communication Equipment (DCE) for remote access to the system

•on-site Data Terminating Equipment (DTE) or TTY terminal for accessing the system

•connecting blocks for the cross-connect terminal

•transformers and centralized power supplies for items such as digit displays on telephones

•optional equipment such as music sources, RAN machines, paging equipment, and CDR devices

•NTAK92 Off-Premise Protection Module for connecting up to four off-premise analog telephones

553-3021-209 Standard 3.00 April 2000