Nortel Networks Option 11C Mini manual Switch settings Ports 0, Switch settings Ports 2

Page 160 of 332 Chapter 12 — Installing the circuit cards

Table 30

Switch settings (Ports 0 and 1)

Port	Port	SW	SW
0	1	1-1	1-2
SDI	DCH	OFF	OFF
SDI	DPNSS	OFF	ON
—	ESDI	ON	ON
Table 31
Switch settings (Ports 2 and 3)
Port	Port	SW	SW
2	3	1-3	1-4
SDI	DCH	OFF	OFF
SDI	DPNSS	OFF	ON
—	ESDI	ON	ON

Table 32

Jumper settings

	Jumper	Strap	Strap	Jumper
Port	location	for DTE	for DCE	location	RS422	RS232
Port 0	J10	C - B	B - A
Port 1	J7	C - B	B - A	J9	C - B	B - A
	J6	C - B	B - A	J8	C - B	B - A
Port 2	J5	C - B	B - A
Port 3	J4	C - B	B - A	J2	C - B	B - A
	J3	C - B	B - A	J1	C - B	B - A

2Insert the card in its assigned slot.

You can install the NTAK02 SDI/DCH card in slots 1 to 3 of the Main Chassis.

3Connect an NTAK19FB four port cable (or an NE-A25-B cable) from the corresponding connector at the back of the chassis. If you use an NE-A25-B cable, terminate this cable at the cross-connect terminal. Because the NTAK19FB cable is equipped with connectors, it does not require termination at the cross-connect terminal.

553-3021-209 Standard 3.00 April 2000