Nortel Networks Option 11C Mini manual Fasten the chassis in position

Chapter 9 — Installing the chassis Page 119 of 332

3Fasten the chassis bracket to the back of the chassis using the four #8-32 machine screws supplied with the bracket kit. See Figure 24.

Note: Make sure that the slot feature on the chassis bracket is at the top of the chassis. Also, the two tabs on the chassis bracket must extend past the bottom of the chassis.

Figure 24

Chassis bracket installed on the back of the chassis

Tabs

Slot feature.

The hook feature on the wall bracket fits into this slot.

4Lift the chassis into place so that the slot on the chassis bracket engages the hook feature on the wall bracket.

Carefully lower the chassis until the hook on the wall bracket fits securely into the slot on the chassis bracket.

5Fasten the chassis in position.

Fasten the tabs, that extend past the bottom of the chassis, to the plywood backboard. Use the two remaining #12 wood screws from the bracket kit to fasten the tabs to the backboard. See Figure 25.

Option 11C Mini Planning and Installation Guide