Nortel Networks Option 11C Mini manual Modifying model trunks, Removing model trunks

Page 330 of 332 Appendix B – Changing preprogrammed data

Modifying model trunks

If you want to modify a trunk, load LD 14 and enter the following commands on the TTY:

LD 14

REQ CHG

TYPE aaa M “aaa” = the type of trunk that you are modifying

MODL YYY “YYY” = the model number of the trunk that you are modifying (between 1 - 127)

Removing model trunks

To remove a trunk model from the system, load LD 14 and respond to the prompts as follows:

LD 14
REQ	OUT
TYPE	XXX M “XXX” = the trunk type of the model that
	you are removing (Examples: COT, TIE,
	DID, FEX, WAT, etc.)
CUST	0
MODL	YYY “YYY” = the model number associated
	with the trunk type you are removing
	(Valid range is 1-127).

Printing model information

To print information about model trunks, load LD 20 and enter the following commands on the TTY:

LD 20

REQ PRT

TYPE TTTT M “TTTT” = the trunk type

MODL YYY “YYY” = the model number. If you want to print all of the models for this trunk type, leave this value blank.

553-3021-209 Standard 3.00 April 2000