Nortel Networks Option 11C Mini manual Activating terminals on a DSL

Chapter 17 — Connecting the telephones Page 251 of 332

3Enter the customized extension number and press the pound key.

You hear a short high-pitched beep which lasts four seconds, followed by silence (relocation tone).

If the extension number is already in use by another telephone, you hear special dial tone again.

If the extension number is not available for use, you hear a fast, high-pitched broken tone (overflow tone), and you must repeat this step.

4Hang up the telephone handset.

After approximately 10 seconds, the telephone is configured.

Note: If other keys require secondary extension numbers, you are prompted until you enter all of the required extension numbers for the model. These extension numbers cannot be defaulted. You are prompted for each additional extension number with three beeps followed by continuous dial tone (special dial tone). When you are programming an extension number, the lamp associated with that number on the telephone is lit.

—————————— End of Procedure ——————————

Activating terminals on a DSL

Refer to the ISDN BRI Administration and Maintenance Guide

(553-3011-311)for information about activating and initializing the terminals that can be connected to a terminal DSL.

Option 11C Mini Planning and Installation Guide