located into the left side of the printer (when viewed from the front).
3.To prevent jams remove the sheets immediately after printing.
4.If the last sheet of film will not feed from the auto sheet feeder, place a sheet of paper underneath it.
Setting up transparency separators
Occasionally electrostatic build up may cause a sheet of transparency film to attach itself to another. To prevent this separator cards must be placed inside the transpar- ency film box. To set up the transparency separators:
1.Cut along the two inner dotted lines (see Figure 1, number 1) on the separator card. Discard the mid- dle portion of the card.
2.Fold the two cards along the dotted line (2). The folded angle should be less than 90 degrees.
3.Take the inner box of the transparency film and insert it into the box cover (3).
4.Insert the separators into each side of the box between outer cover and inner box (4). Make sure the folded angle remains at less than 90 degrees.
5.Place the box with the installed separators into the printer paper tray and align the edge of the box with the centre cover (5) on the printer.
6.When the transparencies are printing they will ride on top of the separators, preventing them from picking up any completed transparencies lying below. When a transparency is completed it will drop through the separators by the time the next sheet begins printing.
Set up the printer driver for printing
1.Select Print from the File menu of your applica- tion. When the dialog box appears, click Proper- ties.
2.Click the Document/Quality tab to bring to the front.
3.Set the Document Type to the appropriate option.
4.Set the Media Type to Transparency Film.
5.In Print Mode select the required colour option.
6.When you complete the setup, click OK to close the dialog box.
7.Click OK in the Print dialog box to start printing.
54 | User’s Guide |
