9Is the cut corner in the correct position (for transparencies and back print film)?
When these sheets are inserted with the cut corner incorrectly positioned, they may not feed cor- rectly. Follow the instructions and insert the sheets correctly.
10Are you printing on envelopes, thermal paper, or picture cards?
Correct printing and feeding of envelopes and thermal paper cannot be guaranteed. The paper side of picture cards can be used if the card is less than 0.23 mm (0.01") thick and manual feed mode is used. Printing on the photo side is unreli- able.
11Are you using
Cards with thickness within the range of 0.07 mm - 0.23 mm (0.003" - 0.01") can only be used in manual feed mode.
12Is there anything blocking the paper output slot (such as a large pile of printed sheets)?
This can cause ejection or feed problems, remove the blocking paper.
13Have you loosened the paper sufficiently prior to loading it into the sheet feeder?
Paper must be riffled several times prior to being loaded into the sheet feeder. If not, sheets of paper may stick to one another and cause multiple sheets to feed into the printer at the same time, or other forms of misfeed.
Printer emits unusual noises when the power is turned on, and the error lights blink
1Has the carriage packing material been removed?
Refer to Chapter 1, Introduction for details on removing packing material.
2Has the packing tape on the case been removed?
There are two pieces of tape on the front of the printer that help protect the printer during ship- ping. These must be removed before using the printer.
3Has an ink cartridge become dislodged from the carriage?
Open the front cover and make sure the ink car- tridges are correctly installed.
74 | User’s Guide |
