mode is used. Printing on the photo side is unreli- able.
10Are you using
Cards with thickness within the range of 0.07 mm - 0.23 mm (0.003" - 0.01") can be used in manual feed mode.
11Are there pages piled up near the output slot or in the output paper tray?
When printed material obstructs the paper output slot, the paper feed and paper output may not work correctly.
12Have you loosened the paper sufficiently prior to loading it into the sheet feeder?
Paper must be riffled several times prior to being loaded into the sheet feeder. If not, sheets of paper may stick to one another and cause multiple sheets to feed into the printer at the same time, or other forms of misfeed.
English
The printer emits unusual noises when the power is turned on, and the error lights blink
1Has the carriage packing material been removed?
Refer to Chapter 1, Introduction for details on removing packing material.
2Has the packing tape been removed?
There are two pieces of tape on the front of the printer that help protect the printer during ship- ping. Gently remove the tape before using the printer.
3Has a cartridge become dislodged from the cartridge holder?
Open the front cover and make sure the cartridges are correctly installed.
4Is there a paper jam?
Clear a paper jam by refering to ‘Clearing Paper Jams’ in this Chapter. Occasionally a small piece of paper will tear off and remain in the printer. If this happens, hold the release lever down and use a thick piece of paper to remove the small piece of paper.
Chapter 7 - Troubleshooting | 87 |
