Programming Console Operations | Section | |
|
|
|
7.Input the second operand (123 to specify 12.3 seconds) and press the WRITE Key. The next program address will be displayed.
B C D
1 2 3 WRITE
00202READ NOP (000)
If a mistake was made inputting the operand, press the Up Arrow Key to return to display the mistaken operand and input the operand again.
Note a) Counters are input in the same basic way as timers except the CNT Key is pressed instead of the TIM Key.
b)Timer and counter SVs are input in BCD, so it isn’t necessary to press the CONT/# Key.
8.Input the third instruction (MOVE) and its operands. First input the instruc- tion by pressing the FUN Key and then the function code (21 in this case).
| C | B | 00202 |
FUN | 2 |
| 1 MOV (021) |
|
|
To input the differentiated version of an instruction, press the NOT Key after the function code (FUN 2 1 NOT). The “@” symbol will be displayed next to differentiated instructions. Press the NOT Key again to change back the instruction back to a
To change an instruction after it has been entered, simply scroll through the program until the desired instruction is displayed and press the NOT Key. The “@” symbol should be displayed next to the instruction.
9.Press the WRITE Key to write the instruction to Program Memory. The input display for the first operand will be displayed.
WRITE
00202 MOV DATA A
000
•Writing Hexadecimal, BCD Constant
10.Input the first operand.
The operands of MOV(21) are normally word addresses, but a constant can be input by pressing the CONT/# Key first. When the CONT/# Key is pressed, the display will change to “#0000,” indicating that a constant can be entered.
CONT | B | A | A | 0 | 00202 MOV DATA A |
| |||||
# | 1 | 0 |
| #0100 | |
|
|
|
|
Press the WRITE Key to write the instruction to Program Memory. The input display for the second operand will appear.
00202 MOV DATA B
WRITE
000
•Writing a Word Address
11.Input the second operand.
*EM | B | A | 0 | 00202 MOV DATA B | |
|
| ||||
LR | 1 |
| LR | 10 | |
|
|
| |||
Press the WRITE Key to write the instruction to Program Memory. The next program address will be displayed.
WRITE
00203READ NOP (000)
Note When the default display value is “000”, a word address can be input immediately without pressing the Shift and CH/# Keys.
85
