1.1.5Inspecting and Unpacking Each Cabinet

NOTE: Refer to the applicable Powerware9315 Installation manual provided with the UPMs for UPM unpacking instructions.

The first task in preparing for installation is inspecting and unpacking the SSBM. The SSBM is shipped in sections which are bolted to wooden pallets and protected with outer protective packaging material as shown in Figure 1---1 and a plastic inner covering.

WOODEN

PALLET

OUTER

PACKAGING

Figure 1---1. Cabinets as Shipped, with Outer Packaging and Pallet

1.Carefully inspect the outer packaging for evidence of damage during transit.

CAUTION:

Do not install a damaged cabinet. Report any damage to the carrier and contact your local sales or service office immediately.

CAUTION:

Only insert the forklift jacks where “FORK HERE” signs appear on cabinet packaging.

2.Use a forklift or other material handling equipment to move the cabinet to a convenient unpacking area. Insert the forklift jacks between the raised supports on the bottom of the pallet.

CAUTION:

Do not tilt cabinets more than 10 degrees from vertical.

3.Set each pallet on a firm, level surface, allowing a minimum clearance of 4.6m (15 ft) on each side for removing the cabinets from the pallets.

1--4

Powerware 9315 Parallel Capacity/Redundant System with PHP SSBM

 

164201373 Rev. A 092402

Page 26
Image 26
Powerware 9315s manual Inspecting and Unpacking Each Cabinet, Cabinets as Shipped, with Outer Packaging and Pallet