Powerware 9315s manual Port Setup Screen

9.6.9Port Setup Screen

Select Port 1 or Port 2 from the Setup menu to display one of the Port Setup screens. The Port Setup screens allow you to specify settings for the two serial communication ports on the UPS. Figure 9---11 shows the Setup Serial Port 1 screen.

		Uninterruptible Power System
UPS System Normal						15 NOV 1997	09:25:45
Alarm:	None
Notice: None
Battery
Minutes			Setup Serial Port 1
48.5
		MODE	RATE	DATA/STOP		HANDSHAKING	SAVE
		TERMINAL	9600	8	1	XON / XOFF	NO
Setup
Port 1
Port 2
Time
Language
Meters	Events	Statistics Graphics	Setup

Figure 9---11. Port Setup Screen

The small return arrow () appears in the upper right corner of the Port Setup

screen. This arrow is a reminder that you can press the pushbutton on the Monitor Panel to toggle the pushbuttons between the menu box and the information area. When the scroll bar is in the information area, the return arrow is in the menu box. When the scroll bar is in the menu box, the return arrow is in the information area.

When the scroll bar appears in the information area, you can use the pushbuttons to change the port configuration. To change a setting, press the and pushbuttons to move the highlight to the setting you want to change. To scroll through the available options for that setting, press the or pushbutton. To save the settings upon exit from this screen, be sure the SAVE field is set to YES.

The setup screens for Port 1 and Port 2 are identical. For detailed information about configuring the serial ports, refer to Chapter 13, “Serial Communications.”

Powerware 9315 Parallel Capacity/Redundant System with PHP SSBM	9--13
164201373 Rev. A 092402