| 5 |
|
|
|
|
| |
|
|
|
|
| Table |
| |
|
|
| |
Menu | Definition |
| |
|
|
| |
NETWORK CONFIG | Used to set the operating mode (Inverse Mux or Single Line DSU), and |
| |
MENU | clocking options of that are common to all E1 Network Ports. |
| |
|
|
| |
NET N CONFIG MENU | Used to set various configurable items that are unique to each individual E1 |
| |
| Network Port, including Framing Format, TS16, Alarm Reporting, Auto- |
| |
| Restore, and Equalization. |
| |
|
|
| |
NET THRESHOLDS MENU | Allows you to enable/disable and set the values of the various Network |
| |
| Alarm Thresholds which, when exceeded, will cause the E1 lines to |
| |
| automatically be taken out of service. |
| |
|
|
|
|
Node Configuration
The NODE CONFIG MENU allows you to configure the NODE ID, NODE NUMBER, DATE & TIME and *NODE COMM PORT (Terminal). It also displays the NODE HW REV and the SOFTWARE REV, which are set by the factory.
NOTE: Only the terminal comm port can be set through the front panel. The network management port is set through the ASCII terminal.
The NODE CONFIG MENU is accessed through the CONFIGURATION MAIN MENU by pressing Enter when NODE CONFIG appears on the display. Pressing the DOWN ARROW or UP ARROW button toggles through the submenus.
Pressing Enter when a selection is in the display allows you to view the present configuration. Pressing Enter again will cause the entry to start blinking and allows you to change the selection if desired.
To change the selection, use the DOWN ARROW and UP ARROW buttons to toggle through the choices. Pressing Enter selects the option that's in the display as the configuration. In the case of changing names and numbers, only one number or letter will “blink” at a time. Only that number or letter can be changed. After each letter or number is selected, press Enter to confirm each change. The next letter or number space will then begin “blinking” and be available for change. To abort any change, press Exit before you press Enter.
Front Panel Interface |
