6.Press ENTER to store the new name. (Or CANCEL to cancel any changes and leave the original file name.)

Configuring fields

If you do not want to change the number of entry fields, skip steps 1-6 below.

1.Press TEL or USER FILE to open the application that you want to set up the fields in.

2.Press MENU , select one of the three CONFIGURE menus corresponding to the file you wish to modify, then press ENTER .

The CONFIGURE submenu appears.

3.Highlight FILE NAME and press ENTER . The FILE NAME window opens.

#4-2-3 Display

Number of fields

 

 

currently set and

 

used in this file.

 

 

4.Move down to NUMBER OF FIELDS and press NEW to clear the current number in the field.

5.Enter the number of fields that you want your entries to have.

If you decrease the number of fields for a file that already has some entries stored, fields and any information they contain will be deleted from the bottom of each entry until the decreased number of fields is reached. Since the data in these fields are lost, care should be taken when reducing the file size.

6.Press ENTER to store the number of fields you entered. (Or CANCEL to cancel any changes and leave the original number of fields.)

7.Press MENU , select one of the three CONFIGURE commands for the appropriate file, then press

ENTER .

The CONFIGURE submenu appears.

8.Select FIELD NAME and press ENTER . The FIELD NAME window opens.

#4-2-4 Display

Current field names

9.Move to the desired fields and change them as required.

Use NEW to clear the current name.

Enter the new name (up to 12 characters). The name can contain letters, numbers, and symbols.

100

Page 102
Image 102
Sharp OZ-5500 operation manual Configuring fields, 100