Robertson AP45 Autopilot | Page |
General Information |
|
Junction units Except for a bigger cabinet, the J45S and the J45A junction units described in this manual are identical to the previous versions,
J45S Junction unit
The J45S Junction Unit will operate continuously running hydraulic power units with directional valves as Robertson RPU3 or similar. The unit contains a printed circuit board with terminal block, fuse, galvanic isolated solid state output to switch the solenoids and start relay for the Power Unit. All mounted in an aluminium cabinet with polyester coating.
J45A Electronic Junction Unit
The unit provides variable speed control of reversible hydraulic power units (e.g. Robertson RPU80, RPU100 RPU160 or RPU200) and mechanical power units (MRD100 or HLD2000). The unit consists of a printed circuit board with terminal block, fuse and drive electronics, mounted in the same type of aluminium cabinet as the J45S.
Optional equipment A series of options are available for the basic AP45 system.
Remote Controls S9
S9 is a splash proof steering lever for bulkhead or console mounting. The unit is constructed of a machined aluminium housing. The internal mechanism of the S9 permits locking of the lever in the
FU91
FU91 is a splash proof steering lever for bulkhead or console mounting. The unit has a
S35 Non Follow Up (NFU) Steering Lever
S35 is designed for indoor and outdoor bulkhead mounting. The lever is spring loaded to midposition. It also has a “Mode” button that is not used when connected to AP45.
F1/2 Remote Control (NFU)
F1/2 is a handheld control for push button steering, fitted with a rubber grip. It is made of cast seawater resistant aluminium and fitted with a 10 meter (30 ft.) cable.
Simrad Robertson AS
Egersund - Norway