Simrad ROBERTSON AP45 manual Select language, AP45 Installation loop

Robertson AP45 Autopilot	Page 6-3
Start-Up procedure / Commissioning

will be shown in the information display instead of each parameter that has got a special value. This is done to avoid that the parameters are re-selected by a mistake.

To continue without further changing the special value: Press the WEATHER button.

To re-select the factory parameter setting:

• Enter the Debug mode as described on page 7-5. (Press hidden button + Weather button).

• Step through the entire debug loop until you find:

PROGRAM: V_R_

RUNTIME: -------------H

• Press - button repeatedly until alarm sounds and display shows:

DATA FAILURE !

CHECK SETTINGS

• By pressing the ALARM button and cancel the alarm the complete set of factory settings are re-selected.

Select language

The text in the Information Display can be presented in four different languages.

Select desired language by pressing the RUDDER and WEATHER button simultaneously. The display shows one of the following

* ENGLISH * F, E, D, N: +/-

languages: ENGLISH, FRANCAIS, ESPANOL, NORSK.

Press the + or - button until the desired language is shown in the display.

Fig. 6-1

AP45 Installation loop

Simrad Robertson AS

Egersund - Norway