Panel mounting Bracket mounting | Simrad ROBERTSON AP45 guide

Page 5-34	Robertson AP45 Autopilot
	Installation

Panel mounting

• Make a panel cut-out of 126 x 102 mm.

• Use the supplied fastening device to secure the unit to the panel. See Fig. 5-41

Fig. 5-41 Panel mounting

•Mount two of the bracket halves to the RI35.

•Temporarily bolt together the other two halves of the bracket to the first two halves.

•Hold the RI35 in place by hand and mark the 4 holes for the fixing screws on the mounting surface.

•Remove the RI35, drill the 4 mounting holes in the mounting surface.

•Unbolt the temporarily fitted bracket halves and secure them to the mounting surface using the self-tapping screws.

•Assemble the complete bracket again and adjust the RI35 to best viewing angle and tighten up the mounting bracket bolts.

Egersund - Norway