Texas Instruments MSP50C614 → deeper sleep … relatively less power →, Component Determined

Reduced Power Modes

Table 2±4. Status of Circuitry When in Reduced Power Modes (Refer to Table 2±3)

		→ deeper sleep … relatively less power →
Component	Determined	LIGHT	MID	DEEP
	by Controls
CPU clock	E	stopped	stopped	stopped
(processor core)
PLL clock circuitry	A, E	running	stopped	stopped
Master clock (MC) status	A, E	running	stopped	stopped
(C614 periphery)
MC rate	B, F	131 kHz … 34 MHz	Ð	Ð
Synchrony of external interrupts	C, E	Synchronous	Asynchronous	Asynchronous
PDM pulsing	D	stopped	stopped	stopped
TIMER1 or TIMER2 status
•Assuming TIMER is enabled	A, B, E	1) running	1) stopped	1) stopped
1) TIMER source = 1/2 MC		2) running	2) running	2) stopped
2) TIMER source = RTO or CRO

If the reference oscillator is stopped by a programmed disable or by an IDLE instruction, then, on re-enable or wake-up, the oscillator requires some time to restart and resume its correct frequency. This time imposes a delay on the core processor resuming full-speed operation. The time-delay required for the CRO to start is greater than the time-delay required for the RTO to start.

There are a number of ways to wake the C614 from the IDLE-induced sleep state. The various options are summarized, as a function of the reduced power mode, in Table 2±5. Naturally, the RESET event (happens after the RESET pin has gone low-to-high) causes an immediate escape from sleep; whereby, the program counter assumes the location stored in the RESET interrupt vector. The RESET escape from sleep is always enabled, regardless of the depth of sleep or the state of programmable controls.

The more functional methods available for waking the device are: 1) the Internal TIMER interrupt, and 2) the external input-port interrupt. For either of these options to work, the respective bit in the interrupt mask register (address 0x38) must be set to enable the associated interrupt service. If the appropriate IMR bit is not set before the IDLE instruction, then the interrupt-trigger event will not be capable of waking the device from sleep. Note also the state of the idle state clock control bit and the ARM bit, if you expect to wake-up using either type of interrupt (internal or external). In most cases, the state of these bits should coincide Table 2±3.

2-38