Toshiba VF-nC1 Parameters related to terminal function selection, Parameter setting

E6581090

Output frequency [Hz]

H ＋ 2.5Hz

H

H － 2.5Hz

0

Specified frequency reach signal: 8

FM/OUT terminal (H)

FL terminal (H)

Specified frequency reach reverse signal: 9

FM/OUT terminal (H)

FL terminal (H)

* FM/OUT terminal function selection (HOUN) : 0 (Output frequency)

Time [sec]

ON

OFF

ON

OFF

Note: Activate H to output signals to the FM/OUT terminal, or set H to 8 or 9 to output signals to the FLA, FLC and FLB terminals.

6.2Parameters related to terminal function selection

6.2.1			Changing the function of the VI/S3 terminal					6
				: Analog input/logic input function selection
		H
		•Function
			This parameter is used to switch the function of the VI/S3 terminal between analog signal input
			and contact signal input.
	■Parameter setting
			Title		Function	Adjustment range	Default setting
					Analog input/logic	0: Voltage signal, 1: Current signal,	0
			H		input function
						2: Contact input
					selection

*To use the VI/S3 terminal as a contact input terminal in sink connection, be sure to insert an adequate resistor* between P15 and VI/S3. (* Recommended resistance: 4.7 kΩ-1/4W)

6.2.2Keeping an input terminal function always active

H

: Always active function selection (ST)

•Function

This parameter allows you to select a function you want to keep always active (ON). (Only one function can be selected.)

■Parameter setting

Title	Function	Adjustment range	Default setting
H	Always active function	0~40, 49, 54~57 (See Section 11.)	1 (ST)
	selection (ST)

6.2.3Changing the function of an input terminal

H : Input terminal selection 1 (F)

H	: Input terminal selection 2	(R)
	: Input terminal selection 3	(S1)
H
	: Input terminal selection 4	(S2)
H

H	: Analog input/logic input function selection *1
	: Input terminal selection 5 (VI/S3)
H
	F-3