
E6581090
3)Sink logic/source logic input
Switching between sink logic and source logic (input terminal logic) is possible.
6.2.4Jog run
• Function
The Jog run refers to jogging or inching a motor. Input of a jog run signal causes the
inverter to produce a jog run signal (fixed at 5Hz) for 0.1 seconds (fixed), regardless of the
specified acceleration time. Cutting off a jog run signal causes the motor to coast to a stop.
■The motor continues to run in jog mode as long as both the jog run signal and the operation signal are put out. To enable the jog run function, you need to assign the jog run function (4) to an unassigned input terminal.
For the
Jogging frequency | 5Hz |
Jogging stop pattern | Coast stop |
Acceleration time | 0.1 sec. |
<Examples of jog run> (When the jog run function is assigned to the S1 terminal: H=4) |
| ||||||
6 | |||||||
|
|
|
| ||||
|
|
|
|
|
|
| |
|
|
|
|
| |||
|
|
|
|
|
| ||
( | Normal operation frequency signal input + | ) |
| ||||
|
|
|
|
| |||
( | Normal operation frequency signal input + | ) |
| ||||
| Output frequency [Hz] |
|
|
| |||
| Set frequency | Forward |
|
|
| ||
|
|
|
|
| |||
|
| Forward Forward |
|
|
| ||
0 | Reverse |
|
|
| |||
|
|
|
|
|
S1
Normal operation frequency setting signal input
•The jog run terminals
•The motor continues to run in jog mode while the jog run terminals
•Jog run has priority, and it continues even if any other operation command is entered during operation.
Note: During jog run, the
6.2.5Switching between control logics
H : Sink/Source selection
• Function
This parameter is used to switch between sink logic (negative common) and source logic (positive common).
■Parameter setting
Title | Function | Adjustment range | Default setting | |
|
| Adjustable within a range of 0 to 200 |
| |
H | Sink/Source selection | 0: Sink | 0 | |
100: Source | ||||
|
|
| ||
|
| Others: Invalid |
|
*The value is changed according to the