Toshiba VF-nC1 instruction manual RSS4

E6581090

(5) Input current setting (4 to 20mAdc) (6) Preset-speed setting

			F			F
			R			R(SS4)
			S1			S1
			S2	RUN		S2	RUN
			P5	STOP		P5	STOP
			P15			P15
			VI/S3			VI/S3
	Current
		signal	CC			CC
		HOQF			Frequency setting
		H (Input current signal)			UT to UT : 1 to 7-speed run
		Use the parameters H to H for			H to H : 8 to 15-speed run
7
		this setting.			(1) To select 3-speed run, use the terminals S1 and S2.
		Set H at 20% or so.			(2) To select 7-speed run, use the terminals S1 to S3 (Add
					S3.).
					H :  (Contact input)
					H :  (SS3)
					(3) To select 15-speed run, use the terminals S1 to S4 (Add
					S4.).
					H :  (Contact input)
					H :  (SS3)
					H :  (SS4)
					Note: When using VI/S3 as an input terminal, be sure to
					short-circuit P15 and VI/S3 with a resistor.
	(7) Setting by means of a remote input device				(8) Setting for switching between voltage/current
					and internal potentiometer

F

R

S1

S2	RUN
P5	STOP

P15

VI/S3

CC

Optional connector

HOQF (Serial communications)

F

R

S1(FCHG)

S2	RUN
P5	STOP

P15

VI/S3

Voltage/current signal

CC

HOQF (Terminal block/internal potentiometer switching) H (Frequency command forced switching)

G-2