E6581090
1.4.4 Installation
■Installation environment
The | 1 | |
the proper operating environment. | ||
|
Danger
•Do not place any inflammable substances near the
Prohibited
•Operate under the environmental conditions prescribed in the instruction manual.
Operations under any other conditions may result in malfunction.
Mandatory
Warning
•Do not install the
Prohibited | This could cause the unit to fall, resulting in bodily injury. |
|
•Check to make sure that the input power voltage is +10%,
| voltage written on the rating label (±10% when the load is 100% in continuous | |
Mandatory | operation) | |
If the input power voltage is not +10%, | ||
| ||
| when the load is 100% in continuous operation) this may result in fire. |
•Avoid operation in any location where there is direct spraying of the following solvents or other chemicals. The plastic parts may be damaged to a certain degree
Prohibited | depending on their shape, and there is a possibility of the plastic covers coming off | |
and the plastic units being dropped. | ||
|
•If the chemical or solvent is anything other than those shown below, please contact us in advance.
(Table 1) Examples of applicable chemicals and solvents
Chemical | Solvent |
Hydrochloric acid | Methanol |
(density of 10% or less) |
|
Sulfuric acid | Ethanol |
(density of 10% or less) |
|
Nitric acid | Triol |
(density of 10% or less) |
|
Caustic soda | Mesopropanol |
Ammonia | Glycerin |
Sodium chloride (salt) |
|
(Table 2) Examples of unapplicable chemicals and solvents
Chemical | Solvent |
Phenol | Gasoline, |
| kerosene, light oil |
Benzenesulfonic acid | Turpentine oil |
| Benzol |
| Thinner |
Note: The plastic cover has resistance to deformation by the above applicable solvents. They are not examples for resistance to fire or explosion.
• Do not install in any location of high temperature, high humidity, moisture condensation and freezing and avoid locations where there is exposure to water and/or where there may be large amounts of dust, metallic fragments and oilmist.
• Do not install in any location where corrosive gases or grinding fluids are present.
