Xerox 128 manual Replacing the highlight color container, Removing the paper seal

Routine maintenance

paper seal by pulling it toward you with the other hand. Discard the seal along with the drop cloth.

Figure 3-10 Removing the paper seal

5.Close the processor access door.

NOTE: If any dry ink should get on your skin, wash with mild soap and cold water.

Replacing the highlight color container

The highlight color container holds the color dry ink. When directed by a screen message, replace the highlight color container. If the highlight color container is not replaced, the printer stops, and it will not operate until the highlight color container is replaced.

CAUTION: Do not use warm or hot water, or general cleaning solvents to remove dry ink from your skin or clothing. The heat or solvent will set the dry ink and make it difficult to remove. If any dry ink should get on your skin, wash with mild soap and cold water.

If any dry ink should get on your clothes, brushing with a dry paper towel or a stiff-bristled brush may remove the ink. If not, launder your clothes with detergent and cold water. Tell a commercial dry cleaner that the spot is dry ink or "toner" so that they will not use a solvent that will set the dry ink stain.

1.Open the front processor access door and locate the highlight color container at the right side of the processor.

2.Place a drop cloth on the floor under the highlight color container area.

3-1 4 DocuTech 128/155/180 HighLight Color Operator Guide