Xerox 128 manual Storing the cart and CCU, Removing the CCU using the service stand

Routinemaintenance

Storing the cart and CCU

NOTE: If any dry ink gets on your hands, wash them with soap and cold water. Heat sets the ink permanently. If any dry ink gets on your clothes, brush them with a dry paper towel or a stiff bristled brush. If this does not remove the ink immediately, launder with detergent and cold water. Tell the dry cleaners that the spot is dry ink for a printer, so they will not use a solvent that sets the stain.

When you are not using a cart and CCU, store them in a dry, dust- free area that has little variation in temperature and humidity. The storage area should have a similar temperature and humidity to the printer room. Maintain the temperature in the range of 60 to 80° F/15 to 26 C° and a relative humidity of 30 to 65 percent.

Removing the CCU using the service stand

Use the service stand to withdraw the highlight color CCU from the printer. Use this stand if you do not have a cart.

To set up the service stand:

1.If the printer is not cycled down, Pause the system before you open the doors and attempt to remove the CCU.

2.Open the printer doors and locate the color housing area in the center of the printer.

3.Place the service stand next to the developer housing.

4.By turning the jack screws, adjust the height of the front feet so that the alignment pins in the service stand are positioned just below the hole and the docking bracket. Tighten the lock nuts on the jack screws to lock the jack screws in position.

Figure 3-18 Service stand

DocuTech 128/155/180 HighLight Color Operator Guide 3- 21