Xerox 128 manual Adding paper to tray 1 or, Preparing the paper tray

Routine maintenance

Adding paper to tray 1 or 2

The following steps must be performed to add paper to tray 1 or 2.

1.Press the Tray unlock button on the front of the tray. Wait for the red "Please wait" light to go off.

2.When the green "Ready to open" light comes on, pull the tray out until it stops.

Steps 3 through 5 of loading paper into tray 1 or 2 are illustrated in Figure 3-3.

3.Press the green release tab.

4.Lift the metal handle on the feed belt and remove any paper under the belt.

5.Move the rear guide to the back of the tray.

Figure 3-3 Preparing the paper tray

NOTE: To load the paper correctly, refer to the label located on the inside panel at the front of the paper tray. Remove any damaged sheets from the top of the stack.

CAUTION: Do not load the paper above the red line. A jam could occur if too much paper is loaded in the tray.

6.Load the required paper into the paper tray. Load paper with the curl side facing down. Load Xerox paper with the package wrapper seam side facing up.

NOTE: When loading drilled paper, be sure to fan the edge where the holes are located.

7.Position the stack against the front right corner of the tray, as shown in Figure 3-4. This is indicated by the green arrow on the bottom of the tray.

3-6 DocuTech 128/155/180 HighLight Color Operator Guide