Xerox 128 manual Closing the binder, Replacing the stitcher spool a

Routine maintenance

Figure 3-50 Cleaning the calipers

Closing the binder

NOTE: Production publisher configuration only

Perform the following steps to close the binder.

1.Push in the binder drawer until it stops.

2.Close the finisher doors.

3.Place the platen cleaner in a safe place.

Replacing the stitcher spool A

NOTE: Production publisher configuration only

Use this procedure to replace stitcher spool A in the system.

Check stitcher spools A and B visually during the warm-up cycle.

Stitcher spool A is the spool on top, and stitcher spool B is the spool on the bottom.

If spool B needs new wire, call the customer support center.

There is a label behind the stitcher panel that gives instructions for replacing the stitcher spool A. Refer to this label if needed.

The following steps must be performed to replace the stitcher spool A.

3-5 2 DocuTech 128/155/180 HighLight Color Operator Guide