Xerox 128 manual Storing the binder tape reels

Routinemaintenance

12.Slowly and carefully pull about 3 feet (1 meter) of wire from the spool.

13.Cut the wire, leaving about 2 inches (51mm) of wire extending from the end of the stitcher plug.

14.Insert the plug into the measuring bracket.

15.Continue to feed the wire until it touches the back plate of the measuring bracket.

16.Push the green stitcher head release handle down and back.

17.Pull the plug from the measuring bracket.

18.Insert the plug into the stitcher head until the plug snaps into place.

19.Place the wire cutters in the storage bracket.

NOTE: Ensure that the wire cutters are not touching the stitcher spools. This can prevent the stitcher wire from feeding properly.

20.Lower the stitcher panel.

NOTE: Ensure that the stitcher panel has been lowered. The stacker will not deliver prints if the stitcher panel is left in the up position.

21.Close the finisher doors.

Storing the binder tape reels

NOTE: Production publisher configuration only

Binder tape contains paper that makes the tape sensitive to the same conditions that affect paper, especially moisture. Figure 3-60 shows good storage conditions for the binder tape.

DocuTech 128/155/180 HighLight Color Operator Guide 3- 59