Xerox 128 manual Replacing the binder tape reel, Opening the binder drawer

Routinemaintenance

Replacing the binder tape reel

NOTE: Production publisher configuration only

Use this procedure to replace the binder tape in the system.

To ensure proper binding and to reduce binder tape jams, do not leave binder tape in the system when the binder is not in use.

If necessary, refer to the label on the binder for instructions on how to replace the binder tape.

The following steps must be performed to replace the binder tape wheel.

WARNING: All areas of the binder drawer, including the binder tape, are hot, approximately 425°F (218°C), and may cause serious burns. If the binder has been in a "Ready" condition, allow the binder drawer to cool at least one hour before continuing the procedure.

1.Open the finisher doors.

2.Grasp the green handle on the binder drawer and pull the drawer out until it stops.

Figure 3-62 Opening the binder drawer

3.Remove the tape from the drive roll.

a.Lift the pressure roll release handle and remove the tape from the drive roll.

DocuTech 128/155/180 HighLight Color Operator Guide 3- 61