Xerox 128 manual Wire Module Removal and Replacement, Wire module retainer springs

Routine maintenance

Wire Module Removal and Replacement

Replace the wire module only when directed to by the Customer

Support Center.

CAUTION: In the following instructions, do not pull on the locating arm of the developer housing. A bent or damaged locating arm can cause component damage or image quality artifacts.

Do no touch the Electrostatic Voltage (ESV) mounted to the top of the developer housing when removing the wire module. The ESV is fragile, and susceptible to damage from electrostatic discharge.

To remove the wire module:

1.Open the processor doors.

2.Using the CCU cart or service stand, slide the HLC developer module out of the printer Refer to the procedures on using the CCU cart or service stand.

Figure 3-29 Wire module retainer springs

3.Release the wire module retainer springs. There is one at each end at the front and back of the developer housing.

CAUTION: Handle the wire module with care since the wires can be damaged or broken easily. Do not touch the donor rolls. Touching the roll surface with your fingers can contaminate the surface, causing image quality problems.

To replace the wire module:

3-3 0 DocuTech 128/155/180 HighLight Color Operator Guide