Xerox 128 manual Clearing the Q1213 sensor, Locating the Q1205, Q1206, and Q1207 sensors

Routinemaintenance

Figure 3-42 Locating the Q1205, Q1206, and Q1207 sensors

4.Brush a folded sheet of paper across each sensor to clear any obstruction.

5.Close the bindexer and finisher doors.

Clearing the Q1213 sensor

NOTE: Production publisher configuration only

Clearing the Q1213 sensor should be performed only when directed by a Customer Support Center Representative.

1.Open the finisher doors.

WARNING: The top of the binder is approximately 425°F (218°C). Do not touch the heated areas or you may get burned. If the binder has been in a "Ready" condition, allow it to cool for at least 1 hour before continuing the procedure.

2.Grasp the green handle on the binder drawer. Pull the drawer out until it stops.

3.Locate the Q1213 sensors, as shown in figure 3-43

DocuTech 128/155/180 HighLight Color Operator Guide 3- 45