Xerox 128 manual Removing the stitcher wire plug

ProblemSolving

Figure 4-24 Removing the stitcher wire plug

5.Remove the stitcher wire plug.

•The stitcher wire plug is located above the binder area, as shown in figure 4-24.

•Press and hold down the release clip.

•Pull the plug out of the stitcher head.

6.Remove any damaged wire.

•Using the wire cutters, slowly and carefully pull approximately 3 feet (1 meter) of wire out of the stitcher plug.

•The wire cutter tool needed to perform this procedure is located next to stitcher spool B, as shown in the lower left corner of figure 4-23.

•Cut the wire carefully, leaving approximately 2 inches (50 mm) of wire extending from the stitcher plug, as shown in figure 4-25.

DocuTech 128/155/180 HighLight Color Operator Guide 4- 27