Xerox 128 manual ProblemSolving

	ProblemSolving
Problem	Suggested Solution
Paper path jams	• Check the area where the jams are occurring to ensure that the paper
	path is clear of paper and other obstructions.
	• If a jammed sheet of paper tears when being removed, ensure that you
	have removed all of the sheet pieces.
	• Ensure that the paper path baffles are in the correct seated position.
	• Ensure that the stock is loaded properly in the trays, with the rear and
	side guides against the stack.
	• Ensure that the stock is not loaded above the bottom of the red line in
	the paper tray.
	• Ensure that the stock has no bent corners, or tears, and that the edges
	are straight. Remove any damaged sheets.
	• Repeated jamming may be due to a paper curl problem that can be
	resolved by adjusting the decurler lever. Refer to the procedure,
	"Adjusting for paper curl," in this guide.
	• Paper weight less than substance 20 (75 g/m2) will require careful
	setting of the decurler. Refer to the procedure, "Adjusting for paper
	curl," in this guide.
	• Fan the stock thoroughly.
	• Ensure that the stock is within the limitations described in the
	satisfaction guides in the "Technical information" chapter.
	• Paper weight less than substance 20 (75 g/m2) will require careful
	storage and handling. Refer to the "Technical information" chapter.
Paper misfeeds and	• Ensure that the stock is loaded properly in the paper trays, with the rear
multifeeds	and side guides against the stack.
	• Ensure that the stock is not loaded above the bottom of the red line in
	the paper tray.
	• Ensure that the stock has no bent corners, or tears, and that the edges
	are straight. Remove any damaged sheets.
	• Check the sheets in the bottom of the paper tray for damage. If they are
	damaged, discard the sheets.
	• Ensure that the stock to be fed out of the paper tray is not excessively
	curled. Refer to the procedure, "Adjusting for paper curl," in this guide.
	• If the misfeeds are occurring in the paper tray, ensure that the paper
	feeder is latched by pressing down on the green dot inside the tray.
	• Fan the stock at all four corners. Change it if it has uneven edges or if it
	was not drilled properly.
	• The stock should be kept in the original wrapper and stored correctly.
	Refer to the "Technical information" chapter.
	• Ensure that the stock is within the limits described in the "Technical
	information" chapter.

DocuTech 128/155/180 HighLight Color Operator Guide 4- 3