Xerox 128 manual Using various stocks, Satisfaction guide for 2-sided printing

			Technicalinformation
Stock	Reliable feeds may	Less reliable feeds may be	Suggested alternatives
	be expected	expected
Type or	Xerographic bond	Slightly curled paper	Do not use excessively curled
condition	paper in good	Intermixed weights	paper
	condition	Xerox vellum	Substance 110 (200 g/m2) must
	Drilled stock, fanned	Full cut tabs	be long grain. Do not use short
	thoroughly	Label stock	grain.
		Adhesive drafting film	Precut tabs - use tray 1 or 2.
		Paper with reinforced edges	Transparencies with a white
			stripe, use tray 1 or 2.
			Freshly printed offset prints, use
			tray 3.
			Refer to the “Using various
			stocks” section for any stock not
			defined in this guide.

Table 5-4. Satisfaction guide for 2-sided printing

Stock	Reliable feeds may	Less reliable feeds may be	Suggested alternatives
	be expected	expected
Size	8 x 10 inches to 17 x		17 x 11 inch (432 x 279 mm)
	11 inches (203 x 254		paper can only be sent to the top
	mm to 432 x 279 mm)		tray.
Weight	Substance 16 to 110		Weights outside the limits shown
	(60 to 200 g/m2)		are not recommended.
	Substance 110 (200
	g/m2) must be long
	grain.
Type or	Xerographic bond	Slightly curled paper	Do not use excessively curled
condition	paper in good	Paper with reinforced edges	paper.
	condition		Refer to the “Using various
	Drilled stock, fanned		stocks” section for any stock not
	thoroughly		defined in this guide.

Using various stocks

The following table lists stock that have been evaluated and tested for use in this system. There are many other stocks available, some of which may not provide the same degree of user satisfaction. Refer to the “Using non-standard stock” section in this guide

DocuTech 128/155/180 HighLight Color Operator Guide 5- 7